Licensed Residential Roofing Contractor in Salt Lake County, UT
Urban Design & Remodel, led by Principal General Contractor Grant Helmer (Utah DOPL License #10146123-5501, (801) 440-1952) in West Jordan, provides code-compliant residential roofing across Salt Lake County. Services span full-tear-off architectural and Class 4 impact shingle replacements ($475–$685 per square), canyon-wind repairs, IRC R905.1.2 ice-dam waterproofing, and turnkey interior drywall restoration under one warranty.
Salt Lake County roofs endure one of North America's harshest thermal and aerodynamic cycles. Sitting between 4,250 and 6,150 feet in elevation, residential rooflines bake under intense high-altitude UV radiation in July, absorb 75 to 95 mph canyon downslope gusts each spring and autumn, and cycle through dozens of freeze-thaw snowmelt events every winter. Unlike single-trade shingle sub-crews that subcontract work without structural oversight, Urban Design & Remodel operates as a full B100/R100 Utah General Contractor based in West Jordan. We engineer complete roof assemblies—decking, ice barriers, flashings, balanced attic ventilation, and interior ceiling repairs—built specifically for Wasatch Front micro-climates.
Complete Tear-Off Roof Systems Engineered for Wasatch Front Weather
Laying new asphalt shingles over curled, heat-blistered layers traps attic heat, hides rotted OSB sheathing, and voids manufacturer wind warranties. Every Urban Design & Remodel reroof starts with a clean tear-off down to bare structural decking so our crew can inspect truss bearing points, re-nail loose panels with 8d ring-shank fasteners per Utah IRC Chapter 8, and replace delaminated boards around plumbing boots and valleys. We install breathable synthetic underlayment across the field, 26-gauge pre-painted steel drip edge along eaves and rakes, and heavy laminated architectural or SBS polymer-modified shingles from Owens Corning, Malarkey, and GAF rated for 130 mph gusts.
- Full tear-off to bare OSB or plank decking with magnetic yard sweep and haul-away
- 130 mph ASTM D7158 Class H high-wind 6-nail fastening pattern on every slope
- UL 2218 Class 4 impact-resistant shingle options qualifying for Utah insurer discounts
Utah IRC Ice-Barrier Compliance & Balanced Attic Ventilation
Across Salt Lake County municipalities—from valley-floor ramblers in Murray and West Jordan to high-snow-load benches in Sandy, Draper, and Herriman—Utah adopts IRC Section R905.1.2 requiring self-adhering polymer-modified bitumen ice barrier extending at least 24 inches inside the exterior warm wall line. On deep 24-inch soffits or steep pitches, that demands two full 36-inch courses (72 inches) of high-temperature ice-and-water shield along eaves, plus full-width lining in open metal valleys and around skylights. We pair membrane waterproofing with NFA-calculated intake and exhaust ventilation (1 sq ft of net free area per 150–300 sq ft of attic floor) to stop winter ice dams and drop summer attic temperatures by up to 30°F.
- Minimum 6-foot eave ice-and-water membrane coverage on wide-overhang Utah homes
- Continuous baffled ridge vents matched to clear aluminum or vinyl soffit intake vents
- 26-gauge step, counter-reglet, and cricket saddle flashings at brick chimneys and stucco walls
Targeted Flashing Repairs, Canyon-Wind Restoration & Leak Diagnostics
Not every leaking Salt Lake Valley roof requires a $16,000 replacement. When UV-cracked neoprene pipe boots, lifted ridge caps after an east-bench windstorm, or improperly integrated stucco kick-out flashings let water intrude, our diagnostic inspections trace moisture pathways from attic rafters down to exterior penetrations. We replace brittle plastic roof vents with galvanized steel slant-back louvers, install lifetime silicone or lead-sleeved plumbing flashings, and re-seal storm-lifted courses using manufacturer-approved asphaltic roof cement and stainless fasteners. When hail or wind meets policy thresholds, we document collateral soft-metal spatter and shingle crease counts clearly for homeowner adjusters.
- Infrared and attic moisture-meter leak tracing without guesswork tar-patching
- Kick-out diverter flashing retrofits protecting vulnerable Utah EIFS and stucco sidewalls
- Lifetime-warranted Ultimate Pipe Flashing and steel exhaust hood upgrades
The General Contractor Advantage: Roof + Interior Ceiling Turnkey Warranty
Standard roofing companies stop at the exterior shingles, leaving homeowners to hunt down separate insulation, drywall, and painting subcontractors while staring at water-stained vaulted ceilings. Because Grant Helmer holds an active Utah DOPL General Contractor license (#10146123-5501), Urban Design & Remodel handles both halves of a roof failure seamlessly. Once the exterior roof assembly or chimney cricket is 100% watertight, our interior crew removes saturated R-38 fiberglass or cellulose insulation, treats framing with EPA-registered antimicrobial solution, hangs 5/8-inch Type X drywall, matches Utah orange-peel or knockdown textures, and primes and paints ceiling planes corner to corner.
- Single-point accountability from exterior ridge cap to interior ceiling paint
- City reroof permit management, mid-roof ice-shield photos, and final municipal sign-off
- Written 10-year workmanship warranty backed by a local West Jordan builder
Salt Lake County Residential Roofing Systems & Installed Cost Guide
| Roofing System / Service | Wind & Impact Spec | Typical Salt Lake Price | Expected Utah Lifespan |
|---|---|---|---|
| Architectural Asphalt Shingle Tear-Off | 130 mph Class H / Class 3 | $475 – $575 per square | 24 – 30 years |
| SBS Class 4 Hail & Wind Shingle System | 130+ mph / UL 2218 Class 4 | $565 – $695 per square | 30 – 38 years |
| 24-Gauge Standing Seam Metal Roof | 140+ mph Concealed Clip | $1,150 – $1,550 per square | 50+ years |
| Flashing, Pipe Boot & Leak Repair | 26-Ga Steel + Ice Shield | $650 – $2,850 per scope | 15 – 25+ years |
Grant Helmer's Utah Field Pro-Tip (DOPL #10146123-5501)
On Salt Lake Valley split-levels and two-stories with brick chimneys wider than 30 inches on the upslope side, Utah IRC R903.2.2 requires a framed saddle cricket—not just caulked counter-flashing. Adding a steel-lined cricket during your reroof eliminates the #1 winter snow-pocket leak point I see across the valley.
Frequently Asked Questions: Roofing Contractor Salt Lake County Ut
Do Salt Lake County cities require a building permit for roof replacement?
Most Salt Lake County jurisdictions—including West Jordan, Sandy, Draper, South Jordan, Murray, Riverton, and Herriman—require a residential reroof permit when tearing off existing shingles or replacing roof sheathing. Urban Design & Remodel pulls the municipal permit, documents 6-foot ice-barrier installation, and schedules final city inspection.
How long does a full residential roof replacement take in Utah?
An average 22- to 32-square Salt Lake County single-family home takes 1 to 2 working days for complete tear-off, OSB deck repairs, ice-and-water shield, underlayment, shingle installation, and magnetic nail cleanup. Complex steep-slope roofs above 8/12 pitch or custom metal accents typically require 3 to 4 days.
Can you install new shingles over my existing roof to save money?
While Utah code prohibits installing a third layer of asphalt shingles, we strongly advise against even a second nail-over layer. Lay-overs prevent inspecting rotted OSB decking, prohibit installing self-adhering ice-and-water membrane directly to wood eaves, add 250+ lbs per square of dead load, and shorten new shingle life.
Which shingles hold up best to Utah's high-altitude sun and canyon winds?
SBS rubberized polymer-modified architectural shingles—such as Malarkey Vista/Legacy and Owens Corning Duration Flex—outperform standard oxidized asphalt in Utah. The rubberized asphalt stays flexible during sub-freezing windstorms, resists granule loss under 4,500-foot UV exposure, and carries UL 2218 Class 4 hail ratings.
Related Utah Roofing, Bathroom & Remodeling Resources
Schedule Your Salt Lake County, UT Inspection or Design Quote
Direct owner consultation with Grant Helmer (Utah DOPL #10146123-5501) — zero high-pressure sales.